- Conduct Process engineering and design, including process configuration and optimization studies
11 days
5,000+ Engineering Technician Jobs - October 2026 - High Salaries - Page 166
Showing 57,366 jobs results for
"engineering technician"
Engineering Coordinator
11 days
12 days
Construction Engineering Manager [SL]
12 days
Construction Engineering Manager-5 Days [SL]
12 days
Construction Engineering Manager-Site Office [SL]
12 days
Assistant Process Engineer - (BKFN-CMP) (12hrs Rotating Shift)
- Support immediate troubleshooting and recovery of equipment or process issues
12 days
Assistant Process Engineer - (BKFN-CMP) (12hrs Rotating Shift)
- Assist in identifying root causes and implementing corrective and preventive actions
12 days
Assistant Process Engineer -(Implant) (12hrs Rotating Shift)
- Maintain, manage & improve department quality key performance index (wafer scrap, defectivity, SPC, FDC, non-conformance lot, excursion etc.)
12 days
Facilities Engineer, Total Water Management
- Support breakdown maintenance and coordinate with contractors or vendors for repairs and servicing.
12 days
Principal Manufacturing Engineer (SSF)
- Ensure compliance with Health, Safety, and Environmental (HSE) requirements and actively support the Zero Harm programme.
12 days
12 days
- No experience required, Structure Training Provided.
13 days
Executive, Engineering Services
- Supervise periodical inspections to identify and address any system anomalies.
21 days
Engineering Specialist (Grinding) - Entry @Joo Koon
13 days
Assistant Process Engineer
- Set up preventive action/solution and robust system to maintain good quality
13 days
13 days
13 days
- Multiple locations hiring: West/ North/ East
14 days
Engineering Specialist (Grinding) - Entry @Joo Koon
- Ensure established parameters, minimal scrap and acceptable levels of output.
14 days
14 days
Senior Process Engineer, CMP
- Develop, validate, and implement process improvements, standards, and controls
14 days
Process Engineer – Leadframe Process - Tooling Expert
- Investigate process and tooling issues, identify root causes, and implement effective corrective and preventive actions.
14 days
- Analyze complex production data sets to identify systemic inefficiencies, yield loss drivers, and cost reduction opportunities.
14 days
Project Engineer (Metal Casting)
- Responsible for FA Inspection of casting and machining services
14 days
OCTG Test - Development Engineer (Oil -Gas)
- Planning, managing, and documenting test results for internal and client review.
14 days
Project Engineer (M-E)
- Assist in verification of all reports and claims relating to civil & structural, geotechnical, architectural and M&E works submitted by the contractors;
14 days
- Support New Product Introduction (NPI) activities and ensure AOI readiness for production ramp-up.
15 days
- Support New Product Introduction (NPI) activities and ensure AOI readiness for production ramp-up.
15 days
Technical Asset Engineer
- Participate in vendor and service provider evaluation/selection based on capability, quality, regulatory compliance, and company requirements.
15 days