全职 Technician 工作, 薪水 up to MYR 5,000, IOG Sales & Marketing (M) Perak 公司招聘中 - Ricebowl

Job Requirements

• Must to select the correct items exp such as parts numbers or etc.
• Need to know the whole of process of filling plan system piping to control the opening or close of valve.
• If no knowledge not suitable to operate the all of valve in filling plan.
• Must to know about the flow of process conveyor line working to operate the conveyor area.
• Must to know the gearbox, conveyor chain, sprocket and conveyor track.
• Knowledge of safety standard in premise and obey the rule of standard safety and procedure that produce by company.
• Awareness that temperature required in the filling plan is room temperature no above 40c (unloading process below 40c and not less 20c).
• Warning: avoid contact with liquid LPG it can cause cool burn for skin.

Job Responsibilities

• Selection of the right procedures to Fabricate assemble, disassemble and test.
• Selection of tools to fulfil the filling plant (Hand tools, Machine and electrical tools, LPG TOOLS WRENCH).
• Assemble & test Valve and controls.
• Comply with safety standards at all times.
• Install bearings, sprockets, transmission gears and hydraulic valves etc.
• Perform other duties as required by the supervisor.
• Temperature control all equipment & machine for gas filing plant.
• When to do fabrication job with welding process, grinder or drilled also do the same process of the above.
• Standby the fire extinguisher at the near location of working area when to do the test run or fabrication job.
• Make sure the emergency stop button on standby mode when to do the test run.
• Double check the connection, switch, sensor or everything that connected together before test run.
• Install the items parts with correct marking position and fix the parts with screw, nuts or connection pin.
• Double check for the spec items (parts numbers or etc) before install the new equipment or parts.
• Do the correct manner, when to open the equipment's with correct open position of equipment (first do first then last do last) and also in installation process condition do reverse operation.
• Marking the original location or position of parts or equipment that need to replace.
• Check the condition items broken that need to change.
• Stop any sensor or switch first if needed.
• Understand three area of filling plan before operate the valve (unloading area of liquid LPG compressor area/ storage bullet tank area/ filling plan area).
• Follow the step of procedure installation to install the new valve.
• Check and replace with new items if the valve is broken.
• Read and comply the safety procedure with the guideline and regulation provided in the CIMAH report.
• Follow and obey the guideline or standard safety produced by the JKKP with time to time of schedule inspection.
• Obey the safety guideline for filling LPG terminals such as MYGAZ.
• Close all electrical connection when need to change anything at conveyor area.
• Routine check the gearbox fluid by follow the preventive checklist (six moth checklist).
• Check the condition of pneumatic system at the filling machine (current supply, seal kits or etc).
• Check machine condition and machine set up to run operation.
• Do the process unloading the liquid.
• Repair and prevent machine broken.
• Search the spare parts supplier when happen breakdown.
• JKKP handling by using MYKKP account.
• Outsite job (outstation project).
• Monitor pressure at LPG compressor and lorry gauge (5bar to 6bar), storage bullet tank, and filling plan (below 12bar pressure set with return valve).

• EPF, SOCSO & EIS contributions (statutory)
• Annual leave
• Medical leave / Sick leave
• Salary increment (based on performance)